Parts
Categories

 Pilot project

 Technical requirements

 Trial
Method

 -

 Plate

 Set

 Heat

 Hot Properties

6.1

 Air drying

 Should be no deformation, no cracking or other damage

6.2

 Nausea drying

 Should be no leakage and significant deformation

6.3

 In-water thermal shock

 Should be no leakage, no deformation, no rupture or other damage

6.4

 Lin Shui thermal shock,

 Should be no significant deformation and other damage, the collector inlet, the thermal properties do not have a serious obstacle to

6.5

Lin Yu

 Should have no water seepage and destruction

6.6

 Strength

 Should have no obvious damage and deformation 
Transparent plastic sheets should not be in contact with the heat

6.7

 Stiffness

 Should be no leakage, no permanent damage and excessive deformation

6.8

 Frame

 There are no obvious use of noise and vibration. 
Should take full account of snow, ice conditions

6.13

 Parts

 Can be replaced, easy to maintain and inspect

6.13

 Solid tight

 Easily fixed in buildings or on the bench, fully guaranteed fixed method and intensity of security

6.13

Suction

 Heat

 -

 Pressure

 No leakage of the heat

6.9

 Material

Materials and the site of contact should not be dissolved to impede the health of the material. A1 Material selection criteria see Appendix A of Table A1

 Welding

Should be in line with GB / T 12467-90 provisions

Coating

 Should be no falling off, reflective and Fabai phenomenon than the absorption of not less than 0.92

6.10

Appearance

 Endothermic the installation of the shell formation, uniform space

6.13

Permeability 

Ming 

Cover

Plate

Transmission

0.78 Of not less than 0.78

6.11

 Hail Suppression (impact resistant)

 Should be no scratches, warp, crack, break down, broken or perforation

6.12

 Material

See Appendix A Table A2

 Frame

Mosaic allowed, but must be sealed and not leaking

6.13

Appearance

 Shell contact with the seal, but should consider the thermal expansion, there are preventive measures. No distortion, obviously scratches

6.13

 Shell (including seals)

 Coating

 Should be no falling off, a certain gloss

6.13

Appearance

 The outer surface should be straight without distortion, no rupture.  To take adequate measures to the anti-corrosion

6.13

 At 
Heat -

Thermal conductivity

Not more than 0.055W / (m ℃)

 Material

 See Appendix A table A3

 Appearance

 Should be packing Yanshi, there should be no obvious shrinkage or expansion of uplift. 
Does not allow a musty, deterioration or the release of pollutants phenomenon

6.13